Husqvarna Motorcycles FE recalls

Brake caliper assembly may be incomplete on the models referred to above due to deviations in manufacturing at our supplier. The anti-rattle plates and cotters may be missing. This may lead to problems on the brake caliper through to brake failure and therefore to serious consequential events

Fix: Check both brake calipers (front and rear) for completeness and in particular whether the anti-rattle plates cotters and pins are present and correctly mounted. If parts are missing then fully assemble with replacement parts in accordance with the repair manual.

155 vehicles · built 24 Apr 2017 to 7 Jun 2017

Anomalies in the manufacturing process have resulted in certain batches of hand brake cylinders with defective machining. This can lead to early wear of the sealing cup in the hand brake cylinder thus leading to impaired braking performance.

Fix: Recall the machines that are likely to be affected and check the batch number of the hand brake cylinder. If the batch number appears on the affected list replace the hand brake cylinder.

73 vehicles · built 15 Jun 2016 to 12 Jul 2016

The M12 aluminium fuel pump nut may not be to specification. This can lead to insufficient sealing allowing fuel to leak. In extreme cases the leaking fuel can cause damage or fire.

Fix: Recall the machines that are likely to be affected and replace the M12 aluminium fuel pump nut. Where necessary the seal will also be replaced.

58 vehicles · built 29 Jul 2015 to 7 Sep 2015

The forks may not have been correctly assembled which could lead to initially knocking and the damping in the affected strut decreasing. If the condition is allowed to progress the inside of the fork will be damaged and the fork may seize.

Fix: Recall the machines that are likely to be affected and remove the fork cap. Check the locking nut for correct torque and tighten if necessary.

416 vehicles · built 11 Jun 2014 to 10 Oct 2014