SEAT Toledo recalls

In vehicles produced in a specific period with airbags from manufacturer Takata in the event of an accident with airbag activation the driver airbag gas generator housing may explode.�

Fix: Inspect the driver�s airbag and replace it if necessary.�

2 vehicles · built 8 Jun 2015 to 25 Apr 2017

Drivers air bag may not inflate at the correct rate.

Fix: Replace the drivers front air bag.

50 vehicles · built 1 Dec 2017 to 17 Dec 2017

Due to a faulty connection parts of the pyrotechnical system could enter the vehicles cabin during deployment.

Fix: On affected vehicles replace the seatbelt(s)

35 vehicles · built 1 May 2016 to 31 Oct 2016

The child lock can disengage without the driver knowing and the door can again be opened from the inside. If children leave the car unnoticed and run into the road there is a risk of accident.

Fix: Recall the vehicles that are likely to be affected and check the function of the manual child lock. If necessary the door lock/s will be replaced.

1,334 vehicles · built 25 Nov 2015 to 14 Apr 2016

The two mass flywheel can become damaged because of a non-optimally designed through-flow restrictor in the clutch pressure pipe. This can lead to a total failure of the flywheel and under unfavourable circumstances to a vehicle fire.

Fix: Recall the vehicles that are likely to be affected and establish the manufacturer of the two mass flywheel. Where necessary replace the flywheel and the breather of the clutch pressure pipe.

1,477 vehicles · built 1 Feb 2004 to 30 Jun 2005

It is advised that on some vehicles fitted with a 3 and 4 cylinder pump injector engine the bolts of the tandem fuel pump cover may break due to a bolt production fault. As a result the pump housing will not be tight and a diesel fuel leak may occur.

Fix: Recalled vehicles will have the pump checked for being of a certain manufacture. If found to be within the affected range the pump housing cover bolts will be replaced.

5,492 vehicles · built 1 Mar 2004 to 31 Aug 2004

Tension cracks may occur on the vacuum pipe to the brake servo in the area of the connections due to a manufacturing fault. Should a vacuum pipe leak the brake servo will loose it's function. This will result in an increase of force which must be applied to the brake pedal. But will not result in a total failure of the braking system.

Fix: Recalled vehicles will have the vacuum pipes checked and if necessary replaced.

26,886 vehicles

The pulley on the engine cooling fan may loosen causing the fan motor to seize leading to a possible electrical overload with fire risk.

Fix: Recall the affected vehicles for the fitment of a modified cooling fan and pulley.

64 vehicles · built 1 Jan 1995 to 31 Dec 1995

The bearing on the engine cooling fan may seize resulting in an electrical overload with potential fire risk.

Fix: Recall the affected vehicles for the fitment of a cooling fan which incorporates a modified bearing.

1,509 vehicles · built 1 Jan 1993 to 31 Dec 1995

The steel brake pipe from the master cylinder to the ABS valve block may chafe on the air cleaner hose. This could result in failure of the pipe with loss of braking on one circuit.

Fix: Recall the affected vehicles shorten and re-route the air cleaner hose to avoid possible contact with the brake pipe. Where chafing has taken place the brake pipe will be replaced.

800 vehicles · built 1 Aug 1991 to 30 Nov 1992

The anti-lock brake electronic control unit may malfunction due to receiving a reversed polarity feed through its earthing system which shares a common earth point with other electrical systems on the vehicle.

Fix: Recall the affected vehicles and alter the wiring system to provide a separate earthing point for the ABS system.

713 vehicles · built 1 Oct 1991 to 28 Feb 1993