Aston Martin Vanquish recalls

On affected vehicles under specific conditions the brake vacuum pump may not generate vacuum reducing brake assistance. This may result in increased stopping distances and increase the risk of a crash.

Fix: Update ESP (Electronic Stability Program) with modified software.

• VANQUISH: 98 vehicles · built 14 Aug 2024 to 26 Jun 2025
• VANQUISH: 13 vehicles · built 7 Jan 2025 to 22 May 2025

Due to a communication error between the Engine Control Module (ECM) software and the Transmission Control Module (TCM) the transmission park pawl may not engage. In certain circumstances such as when the park brake is not applied the vehicle may roll away.

Fix: On affected vehicles update the software for the Transmission Control Module.

3,849 vehicles · built 18 Dec 2007 to 11 Jan 2017

In some circumstances when the right side front seat is operated to its fully reward position the seat runner can compress the battery supply cable and cause the seat to damage the battery supply cable. This may cause an open circuit and/or ground the supply cable which may then overheat.

Fix: On affected vehicles examine the battery supply cable for damage and install a routing block to ensure that the seat runner cannot compress the battery supply cable. If necessary replace the cable.

6,542 vehicles · built 19 Dec 2003 to 17 Nov 2015

On affected vehicles the right fron seat can compress the battery supply cable. Prolonged occurences coulld cause damage to the insulation and the cable may short out

Fix: Fit new cable guide to reroute supply cable. Check condition of supply cable and where necessary reinforce insulation . In rare instances the cable may require replacement.

691 vehicles · built 3 Sep 2012 to 14 Nov 2015

The electronic throttle pedal assembly cross shaft can become displaced from its housing following involuntary displacement of an ultrasonically domed head (LHS end). This is designed to keep the cross shaft in place along with a secondary retaining cross pin at the opposite side of the housing. With the cross shaft displaced throttle control is lost. If ignored a failed cross shaft would lead to loss of throttle control whilst driving.

Fix: Likely to be affected vehicles will be recalled at which time the throttle assembly will be checked for compliance with specification. Should a non-compliance be identified the throttle pedal assembly will be replaced.

473 vehicles · built 10 Nov 2001 to 9 Nov 2004