BMW X2 recalls

On affected vehicles the front seat belts may have damage to the torsion bar caused during manufacture. The retention function of the seat belt may not perform as expected in the event of an accident.

Fix: Affected vehicles will have the affected seatbelts replaced.

224 vehicles · built 18 Jun 2025 to 28 Jul 2025

On affected vehicles the brake servomotor was improperly welded. The weld seam might not withstand the stresses caused under high brake pressure leading to a requirement for a higher brake effort increasing the braking distance.

Fix: Affected vehicles will have the hydraulic unit of the brake system replaced.

8 vehicles · built 4 Apr 2024 to 22 Jun 2024

On certain vehicles the Integrated Brake (IB) system may be impaired due to contamination between electrical contacts.

Fix: Vehicles that may be affected by contamination are required to have the vehicle’s software updated which can detect signal interference before it occurs. If symptoms are detected you should refrain from use of the vehicle and the affected Integrated Brake (IB) system component will be replaced.

2,437 vehicles · built 11 May 2023 to 27 Jun 2024

On affected vehicles the welding of the recliner adjustment on the backrest of the left front seat may not have been performed to specification potentially resulting in insufficient locking of the backrest.

Fix: On the affected vehicles the Left front seat backrest will be replaced.

4 vehicles · built 23 Apr 2024 to 11 May 2024

The micro gas generator within the front seatbelt�s retractor may have been damaged and may not act according to the specification in the event of an accident.

Fix: On the affected vehicles the front seatbelts will be checked and replaced if they are found to have been damaged

2,018 vehicles · built 18 Feb 2022 to 18 Feb 2022

The material quality of seat and seatbelt screws may not be according to specification.

Fix: On the affected vehicles the screws will be replaced in specific locations on the seat belts or rear seats.

38 vehicles · built 21 Oct 2021 to 21 Oct 2021

A possibility of impurities contained in the HV batteries may cause short circuit.

Fix: Testing of battery charge cycles and replacement of the HV cells where necessary.

2,665 vehicles · built 12 Feb 2020 to 30 Sep 2020

In very rare cases welding beads were not always completely removed in the cleaning process during battery production.

Fix: Test and replace the High Voltage batteries if affected.

871 vehicles · built 10 Jul 2020 to 18 Jul 2020

The affected vehicles may be equipped with a crankshaft sensor with a software fault. The crankshaft sensor cannot process the signal values from the crankshaft transmitter due to an improper firmware level. The firmware does not compensate sufficiently the temperature gradients and the magnetic field strength of the sensor electronic. If the crankshaft sensor cannot process the signal values from the transmitter the Digital Diesel Electronic (DDE) will notice that and change to the emergency operation mode. The emergency mode will be displayed by the check control message �engine malfunction�. The driver may notice a rough running engine and a reduced driving power (70%). However an engine stalling during driving conditions cannot be excluded.

Fix: On the affected vehicles the crankshaft sensor will be replaced with a new version.

4,025 vehicles · built 16 May 2018 to 7 Jun 2018