Volkswagen Jetta recalls

On vehicles with diesel engines and stop/start system the starter motor may be permanently activated because the return spring in the solenoid switch is bent or broken. If the permanent current supply to the starter motor is not noticed overheating of the component with local scorching damage and a vehicle fire is possible.

Fix: Recall the vehicles that are likely to be affected and replace the solenoid switch.

16,625 vehicles · built 1 Mar 2011 to 30 Nov 2011

On vehicles with ABS/ESC the earth connection may be interrupted. This may cause failure of the ABS/ESC system

Fix: On affected vehicles install new software. Where necessary a new ABS/ESC control unit will be fitted.

64,192 vehicles · built 1 Jun 2008 to 31 May 2010

On vehicles with torsion beam rear axle the trailing arm of the rear axle can be deformed in a rear impact of the vehicle or when reversing too quickly over a relatively high obstacle (such as very high kerbs). If this deformation or pre-damage is not recognised a trailing arm of the rear axle can suddenly break later because of the related weakening of the rear axle.

Fix: On vehicles which have been involved in a rear impact or reversed at speed over a high obstacle. The trailing arm of the torsion beam rear axle is checked for accident damage and replaced if necessary. In other instances a brace plate will be fitted to the trailing arms.

5,286 vehicles · built 1 Oct 2011 to 1 Aug 2013

In rare cases an incorrect interpretation of the clutch temperature can occur which results in the clutch opening unexpectedly with loss of drive.

Fix: Recall affected vehicles and update/reprogramme gearbox control unit.

3,514 vehicles · built 1 Sep 2008 to 31 Aug 2009

The contact resistance on the earth connection of the heating element for the additional air heater can exceed specification. This could lead to excessive heat developing in the connection area of the cable which could result in localised scorching. However if not rectified this could result in a vehicle fire.

Fix: Recall all affected vehicles and check the torque on the earth connection.

10,436 vehicles · built 8 Jan 2007 to 9 Jan 2008

Operation of the vehicle for prolonged periods with the cooling system at very high temperatures can result in cooling system damage which in rare instances may cause rupturing on the heat exchanger. In consequence high temperature coolant

Fix: Recall the affected vehicles for the fitment of a bypass valve to the heat exchanger inlet and a non-return valve to the system. At the same time the heat exchanger box will be lined with absorbent foam.

86,500 vehicles · built 1 Aug 1989 to 31 Aug 1991