Ford Tourneo Connect recalls

Affected vehicles may have been repaired using a coolant pump with a potential issue. This issue may lead to incorrect engine timing resulting in an engine failure causing a sudden loss of power without prior warning. The engine cannot be restarted.

Fix: Check and replace the water pump and timing belt if necessary.

• TOURNEO CONNECT: 1 vehicle · built 27 Jun 2019 to 27 Jun 2019
• TOURNEO CONNECT: 1 vehicle · built 24 Feb 2022 to 24 Feb 2022

Affected vehicles may not have the remedy for recall 22C32 installed correctly. These vehicles may still have the incorrect configuration loaded onto the Body Control Module which may prevent the position lights from functioning as intended.

Fix: Update the Daytime Running Lamps configuration and perform a software verification procedure.

• TOURNEO CONNECT: 1 vehicle · built 31 Oct 2019 to 31 Oct 2019
• TOURNEO CONNECT: 1 vehicle · built 25 Jul 2019 to 25 Jul 2019

Affected vehicles could potentially have the Front Entertainment Control Module (FEM) screen freezing. The issue could increase the risk of missing persons or obstacles behind the vehicle when reversing with a frozen rear-view camera picture.

Fix: Update the FEM software and perform a verification process. Replace the FEM if necessary.

1,543 vehicles · built 19 Oct 2023 to 25 Mar 2024

Affected vehicles potentially have a leaking screw connection in the rear left brake circuit. There is potential for the brake system to lack hydraulic pressure resulting in longer brake pedal travel and reduced brake performance.

Fix: Replace the affected part.

84 vehicles · built 4 Aug 2024 to 27 Aug 2024

There is a possibility the lower control arm might not meet manufacturing specification due to missing weld seams. In the event of the lower control arm not meeting specification this could potentially lead to a lower arm failure. If this happens the user may experience potential limited steerability causing a hazard to vehicle occupants and to other road users.

Fix: Visual inspection of affected parts . Any vehicle that has failed this inspection will have the affected part replaced.

3 vehicles · built 23 Jun 2022 to 27 Jun 2022

It has been identified that the mating surface of the vehicle body for the panoramic glass roof panel may have been contaminated during the primer phase of the instigation process. There is a possibility that this could cause poor adhesion between the panoramic glass roof panel and the vehicle body. This could result in wind noise water leaks and in the worst cases detachment of the panoramic glass roof.

Fix: Recall all affected vehicles to remove clean body and re-bond the panoramic glass roof panel.

313 vehicles · built 4 Oct 2013 to 14 Jul 2014