Renault Midlum recalls

Some steering shafts were assembled with an incorrect component.

Fix: Inspect the steering shaft identification number. Depending on the identification number on the part then the steering shaft may require replacement.

5 vehicles · built 2 Apr 2011 to 3 Apr 2022

Under excessive force to the belt the lock ring in the passenger seat belt retractor might break and the belt could become extendable. This will increase the risk of injury during a collision.

Fix: Recall the vehicles that are likely to be affected to replace the passenger seat belt retractor and support.

223 vehicles · built 1 Jan 2010 to 30 Nov 2015

Risk of losing steering due to the incorrect tightness of the universal joint fixing screw.

Fix: Retighten screw if required to the correct torque and paint mark on screw and the clamp

10 vehicles

Engine oil may leak due to the turbocharger oil pipe not being to specification. If not corrected this concern could lead to a skid danger to other road users catastrophic failure of the turbo/engine or in the worst case fire.

Fix: Recall the vehicles that are likely to be affected to replace the turbocharger oil l pipe.

77 vehicles

It has been identified that the front brake chambers of affected vehicles may have been incorrectly torqued. Should this be the case detachment of the chamber and subsequent loss of braking effort at the affected wheel station may occur.

Fix: Recalled vehicles will have the front brake chambers checked for conformity. The chambers will be replaced should any nonconformance be found.

22 vehicles · built 3 Sep 2007 to 17 Sep 2007

It has been identified that the risk of a short circuit exists between individual wires of the engine wiring loom.

Fix: Recalled vehicles will have the engine wiring loom checked for condition and wear and will proceed as follows. If no wiring cores are visible a protective sheath will be fitted to the wiring loom. If the core of one or more of the wires is visible the wiring loom will be replaced.

1,100 vehicles

Due to a manufacturing error an excess of paint has been applied to the wheel mounting faces. In consequence the possibility exists that there may be a loss of wheel fixing torque.

Fix: Recalled vehicles will have any excess paint removed from the mating and locating surfaces of the wheels.

101 vehicles · built 16 Aug 2005 to 13 Oct 2005

There is a possibility that due to a manufacturing defect the high pressure fuel delivery pipes may rupture and leak fuel

Fix: Recall affected vehicles and replace fuel pipes with quality assured type

111 vehicles · built 16 Oct 2003 to 23 Feb 2004

There is a possibility that the seat belt may not lock when required

Fix: Recall affected vehicles to check and replace if necessary the lap safety belt reel on the dual passenger seat

76 vehicles · built 16 Jul 2003 to 17 Oct 2003

The pipe connection on the non return valve fitted to the park brake circuit may separate from the connector due to a manufacturing defect. This could cause unintended application of the parking brake.

Fix: Fit a replacement quality assured non return valve.

233 vehicles · built 17 Feb 2003 to 24 May 2003

The studs securing the front and rear brake chambers may have received the incorrect heat treatment. As a consequence a brake chamber could become detached from it's mounting bracket.

Fix: Check and replace the front and rear brake chambers where found necessary.

408 vehicles · built 13 Jan 2003 to 24 Apr 2003