Volvo V70 recalls

There is a risk for trapped air to be in the cooling system which may result in insufficient cooling of engine components.

Fix: Add an extra degassing line (Bleeder Hose) between the cooling system radiator and the cooling system expansion tank which will evacuate the trapped air

76,945 vehicles · built 7 Nov 2013 to 28 Apr 2016

There is a risk for trapped air to be in the cooling system which may result in insufficient cooling of engine components.

Fix: Add an extra degassing line (Bleeder Hose) between the cooling system radiator and the cooling system expansion tank which will evacuate the trapped air.

15,167 vehicles · built 21 Nov 2012 to 27 May 2016

Potential breakage/fatigue of a flexible steel cable supporting the front seatbelt anchor point.

Fix: Replace the seat belt fastener with a new designed seat belt fastening.

170,160 vehicles · built 14 Mar 2007 to 27 Apr 2016

The engines plastic inlet manifold may melt and deform

Fix: Update vehicles with improved soot reducing software cleaning of TMAP and EMAP. Fit additional hoses where necessary.

• V70: vehicle count not given · built 21 Nov 2012 to 27 Apr 2016
• V70: vehicle count not given · built 7 Nov 2013 to 26 Apr 2016
• V70: vehicle count not given · built 20 Apr 2015 to 22 Apr 2016

Small cracks on the inside of a rubber fuel hose.

Fix: Replacement of affected fuel hoses.

30,777 vehicles · built 11 Apr 2015 to 30 May 2016

It has been identified that during the engine warm-up process and under certain driving/climate conditions for instance periods of high acceleration or high engine load immediately after a cold start in cold climates there is the possibility for coolant leakage or oil seepage. This can lead to the possibility in a worst-case scenario of smoke or a slow developing fire in the engine compartment. However the driver will receive a warning message on the Driver�s Information Module indicating a low coolant level.

Fix: Recall all affected vehicles to modify the coolant bypass valve and install a new exhaust manifold gasket.

3,192 vehicles · built 27 May 2010 to 17 Apr 2015

Involved vehicles may have a software issue which could cause the engine to momentarily cut-out and restart while driving. This could also cause disturbances in some electrical systems such as shut down of the instrument cluster infotainment system and loss of power steering assistance.

Fix: Recall the vehicles that are likely to be affected and upgrade the software of the control units.

7,237 vehicles · built 17 Apr 2015 to 18 Feb 2016

Fuel gauge may not show correct level

Fix: The remedy is not yet available for all models. Until a remedy is available the manufacturer advises to maintain fuel level above approx one third.

1,109 vehicles · built 21 Nov 2014 to 20 Apr 2015

Fuel gauge may not show correct level

Fix: The remedy is not yet available for all models.. Until a remedy is available the manufacturer advises to maintain fuel level above approx one third.

2,743 vehicles · built 21 Nov 2014 to 17 Apr 2015

Fuel gauge may not show correct level

Fix: Dependent on affected Model update software. Until updated the manufacturer advises to maintain fuel level above approx one third.

5,354 vehicles · built 24 Apr 2014 to 11 Dec 2015

The crankshaft may not have been sufficiently hardened and may fail this in turn can lead to sudden and catastrophic engine failure. The failure may be preceded by loss of power and a knocking noise.

Fix: Recall the vehicles that are likely to be affected and replace the engine.

5 vehicles

Vehicles with manual gearboxes and start/stop functionality have Parking Brake Module (PBM) software that may allow the parking brake to unintentionally release. The unintended release of the parking brake can only occur when the engine is running and the gearstick moved so it will happen when the vehicle is attended.

Fix: Recall the vehicles that are likely to be affected to download upgraded Parking Brake Module (PBM) software.

2,146 vehicles · built 24 Feb 2011 to 2 Feb 2015

The auxiliary drive belt tensioner can suffer from premature wear which may cause it to fail. This can lead to loss of steering power assistance and a slight possibility of loss of drive should the drive belt or tensioner invade the cambelt area.

Fix: Recall the vehicles that are likely to be affected to replace the auxiliary drive belt and tensioner.

3,134 vehicles

Investigations have identified the wiper arm mechanism may chafe against the brake booster vacuum line. If this chafing occurs it could lead to a gradual reduction of the power assisted braking and more effort would need to be applied to the brake pedal than usual to slow the vehicle down. In a worst case the reduction of braking assistance could occur suddenly without any prior warning

Fix: Inspect the brake booster vacuum line. If it is chafed then it should be replaced and routed correctly. If the line is not chafed it should re-routed to ensure no issues going forward.

3,394 vehicles

There could be a sudden and unexpected failure of the bottom end of the engine because of a non-conformity during production of the connecting rods.

Fix: Recall the vehicles that are likely to be affected to replace the engine.

6 vehicles

It has been identified that the wiring harness for the SRS system may not have been correctly attached to the front seat frames. It is possible that continued adjustment of the seat position may cause the harness to become detached. If this should occur a warning light will illuminate on the instrument panel warning the driver of a fault with the SRS system. However in this condition the front and side airbags may not deploy if the vehicle is involved in a collision.

Fix: Recall all affected vehicles for an inspection of the wiring harnesses and ensure that it is correctly routed and secured. If not then reroute and securing of the wiring harness.

9,330 vehicles

The auxiliary drive belt tensioner may fail. This can lead to loss of steering power assistance and a slight possibility of loss of drive should the drive belt or tensioner invade the cambelt area.

Fix: Recall the vehicles that are likely to be affected to replace the auxiliary drive belt and tensioner.

7,302 vehicles · built 1 Jan 2007 to 31 Dec 2009

The auxiliary drive belt tensioner may fail. If the tensioner fails it would cause a loss of power steering assistance and possible loss of drive.

Fix: Replace the auxiliary drive belt tensioner.

9,936 vehicles · built 1 Jan 2009 to 31 Dec 2010

It is possible that the upper power steering return line may become detached which will result in the loss of power steering fluid. This will result in fluid leaking onto the road surface leaking into the engine bay and the driver experiencing heavy steering.

Fix: Recall the affected vehicles for the replacement of the power steering return line.

213 vehicles

It is possible that water can enter the electric hydraulic power assisted steering pump. This can affect the operation of the pump. The driver will receive warning in the form of warning messages and illumination of warning lights on the dashboard. However the power assistance for the steering can failure but in extreme circumstances the engine can unexpectedly stall.

Fix: Recall all affected vehicles and replace the power assisted steering pump.

190 vehicles

It is possible in certain circumstances for the engine oil level to rise above the maximum level. This situation could lead to engine speed being maintained or possibly increased after the throttle pedal is released. In extreme cases the engine could continue to run after it has been switched off.

Fix: Recall the vehicles that are likely to be affected to adjust the engine oil level and carry out a software upgrade.

4,787 vehicles

On certain five cylinder engines it is possible that the high pressure fuel pipes may not have been correctly installed and may leak. This should be identified by a smell of fuel from the engine bay. However it is possible that in extreme cases an engine bay fire could occur.

Fix: Recall all affected vehicles and replace the high pressure pipes.

845 vehicles

When driving at low speeds a fault within the software calibration of the engine and transmission control modules may lead to a drop in the engine idle speed when braking or releasing the accelerator. In extreme cases this may result in the engine cutting out without warning.

Fix: Recall the vehicles that are likely to be affected to upgrade the engine/transmission software.

64 vehicles

It is possible that the engine oil level may rise above its maximum level due to overfilling and/or dilution by fuel. This may result in the engine speed being maintained or possibly increased after the throttle pedal has been released. In extreme cases it is possible that the engine may continue to run after it has been switched off.

Fix: Recall all affected vehicles and carry out an Engine Control Module software upgrade and adjust the engine oil. The new ECM upgrade will improve adaption of different blends of fuel and include a dashboard text warning message if the oil level reaches too high a level.

4,430 vehicles

It has been identified that the standard wheel securing bolts may not have undergone the correct hardening process. This will result in corrosion a noise and/or vibration. If this condition is not rectified there is a possibility that the wheel may become loose and detach.

Fix: Recall all affected vehicles and replace the standard wheel bolts.

186 vehicles

It is possible that an electrical short circuit within a connector could result in the illumination of the Airbag System Service Required message and Supplemental Restraint System warning lamp on the dashboard. Should this occur the driver's airbag would not deploy as intended if the vehicle is involved in a collision.

Fix: Recall all affected vehicles to check and rework the connector.

6,844 vehicles

On effected petrol and diesel engines a spring clamp on the radiator hose connecting it to the water inlet pipe may be insecure. If not rectified the engine may lose coolant overheat seize and suddenly slow the vehicle rapidly to a halt.

Fix: Recall the vehicles that are likely to be affected to have the radiator hose adequately secured.

326 vehicles

A section of the gear shift mechanism may over time become loose and cause the mechanism to become jammed. If this was to occur it might not be possible to change gear or select neutral.

Fix: Recall the vehicles that are likely to be affected to check that the ball joint for the gear selector is properly secured.

6,961 vehicles

A joint on the high pressure line of the power assisted steering may not have been assembled correctly. This may lead to a leakage of steering fluid into the engine bay. This could result in sudden loss of power assistance but in extreme cases it could result in a localised fire within the engine bay.

Fix: Recall affected vehicles to check and if required torque the unit up to the correct specification.

260 vehicles

The auxiliary drive belt tensioner may fail. This can lead to loss of steering power assistance and a slight possibility of loss of drive should the drive belt or tensioner invade the cambelt area.

Fix: Recall the vehicles that are likely to be affected to replace the auxiliary drive belt and tensioner.

4,673 vehicles

The engine oil level may rise. This situation may lead to the engine speed being maintained or possibly increased after the throttle pedal is released. In an extreme situation the engine may continue to run after it has been switched off.

Fix: Recall the affected vehicles and carry out a ECM software upgrade adjust engine oil level and install a decal to confirm oil level to the consumer.

20,204 vehicles

The Auxiliary Belt Tensioner may fail resulting in loss of Power Assisted Steeering and loss of Drive

Fix: Recall affected vehicles to replace the Tensioner and Drive Belt.

2,297 vehicles

It has been identified that due to internal leakage the gearbox hydraulic control module may not be able to engage or shift gears as intended.

Fix: Recalled vehicles will have the gearbox replaced.

42 vehicles

It has been identified thatthe fuel pump electronic module may not operate as intended. This can result in failure of the fuel pump to start. Should this occur the vehicle may suffer a non start rough running or in the worst case the engine may stall without prior warning. Investigation has shown that it may be possible to drive the vehicle for up to 100 m before the fault manifests itself.

Fix: Recalled vehicles will have the software within the central electronic module upgraded.

254 vehicles

It has been identified that the fuel pump pressure regulator may detach from it's spigot within the fuel pump in conditions of high ambient temperature. Should this occur the vehicle would suffer loss of fuel pressure causing the engine to stall with no warning being given to the driver.

Fix: Recalled vehicles will have the fuel pump replaced.

5 vehicles

It has been identified that due to a software issue with the engine cooling fan control module the air conditioning performance may be reduced and the engine coolant temperature may increase. This will result in warning messages being displayed. In extreme cases if the driver does not heed the warnings the engine may fail.

Fix: Recalled vehicles will have the cooling fan control module replaced.

4,006 vehicles

Brake assistance from the vacuum pressure pump may be reduced under certain cold start conditions. The brakes will still function but more pressure on the pedal will be required than normal.

Fix: Recall the vehicles that are likely to be affected to replace the non-return valve in the vacuum pump.

2,004 vehicles

The wipers could function without being turned on or not at all because of a software error in the central electronic module.

Fix: Recall the vehicles that are likely to be affected to upgrade the software in the central electronic module.

2,216 vehicles

It has been identified that on vehicles fitted with a supplementary cabin heater the unit may contain a faulty valve which links the heater to the climate control. The valve in question may become clogged which could lead to poor water drainage and in extreme cases a short circuit. Should sufficient heat be generated by the short circuit a fire behind the instrument panel below the radio may occur.

Fix: Recalled vehicles will have the subject valve replaced.

8,255 vehicles

It has been identified that due to a problem within the engine ECU (flexi-fuel engines only) the engine torque may be reduced with the attendant possibility that limp home mode may be activated.

Fix: Recalled vehicles will have the engine ECU software upgraded.

5 vehicles