Citroen Dispatch IV recalls

Some vehicles may have been equipped with an incorrectly positioned fuel pipe.

Fix: Check fuel pipe positioning correct if necessary and fit protective sleeve.

1,507 vehicles · built 29 Jan 2020 to 21 Jan 2022

On the affected vehicles equipped with a manual handbrake the efficiency of the handbrake and service brake may be compromised

Fix: Check the rear brake caliper references and replace as necessary

27 vehicles · built 20 Jan 2022 to 28 Jan 2022

The High Voltage Harness might not be to the correct specification.

Fix: Check the harness conformity and replace it if necessary.

11 vehicles · built 28 Mar 2022 to 29 Apr 2022

Affected vehicles may have been equipped with headrests on the front modular seat which do not conform to the design specification.

Fix: Check the conformity of the front headrests (presence of the catch); in cases of non-conformity the front headrests will be replaced.

359 vehicles · built 16 Nov 2021 to 16 Dec 2021

The rear window electrical harness could become displaced from its original position and present a potential thermal issue.

Fix: Check the routing of harness and replace the electrical harness if necessary. Add a fastening clip to ensure that the electrical harness will be maintained in its normal position.

1 vehicle · built 20 Oct 2015 to 13 Oct 2016

A single wheel bolt on both Right-hand wheels may not be tightened to the correct tightening torque.

Fix: Check and if necessary replace wheel bolts and any other associated parts if consequential damage has occurred.

7 vehicles · built 24 Sep 2020 to 11 Nov 2020

A single wheel bolt on both left-hand wheels may not be tightened to the correct tightening torque.

Fix: Check and if necessary replace wheel bolts and any other associated parts if consequential damage has occurred.

12 vehicles · built 24 Sep 2020 to 11 Nov 2020

Certain seals in the front wheel arches may not be correct to specification and may cause water ingress into the passenger compartment

Fix: Resealing these areas checking for the presence of water in the passenger compartment and replacing certain components in the interior if required.

15 vehicles · built 15 Oct 2019 to 31 Oct 2019

There is a risk of inadvertent release to the front outer passenger seat belt.

Fix: Modifying the central seat buckle with foam and heat-shrinkable protective tubing.

16,122 vehicles · built 16 Apr 2015 to 23 Apr 2019

Possible slackening of the front wishbone ball joint.

Fix: Increasing the tightening torque of the ball joint and adding thread lock if the ball joint threads are found to be rusty or loose the ball joint will be replaced.

• DISPATCH IV: 11,023 vehicles · built 16 Apr 2015 to 23 Apr 2019
• DISPATCH IV: 11,023 vehicles · built 21 Sep 2015 to 23 Nov 2018

The rear suspension wishbone mountings bolts may not be correct to specification.

Fix: Replacement of the rear suspension wishbone bolts.

313 vehicles · built 6 Oct 2016 to 19 Oct 2018

The fixing bolt of the front Suspension wishbone may not be correct to specification.

Fix: Replace the fixing bolts and nuts of the front suspension wishbones.

47 vehicles · built 1 Jul 2016 to 11 Sep 2018

The steering rack assembly may not be correct to specification.

Fix: Replace the steering rack assembly and the fixings.

10 vehicles · built 25 Oct 2016 to 21 Sep 2018

Excessive loading of the front suspension could result in the loosening of the front wishbone lower ball joints.

Fix: Increasing the tightening torque of the ball joint and adding thread lock to the ball joint threads if the ball joint threads are found to be rusty the ball joint will be replaced.

2,633 vehicles · built 1 Jan 2015 to 30 Nov 2018

The air conditioning compressor pulley could break and damage other components.

Fix: Replace the air conditioning compressor pulley and if necessary the protective cover.

2,310 vehicles · built 8 Sep 2015 to 27 Mar 2018

The tow ball bracket could not withstand mechanical constraints when subjected to the highest stress levels which can occur during the vehicle's lifetime.

Fix: The manufacturer�s remedy involves the replacement of the tow ball support bracket with a redesigned version.

103 vehicles · built 13 Nov 2015 to 5 Oct 2017

The cooling system strategy and the maximum temperature alert could cause the engine to overheat this may cause an oil leak from the sump drain cap. Due to the incorrect operation of the warning system there is no driver alert.

Fix: The remedy involves downloading new engine management software.

660 vehicles · built 17 Feb 2016 to 26 Feb 2018

On the affected vehicles the tightening of a sealing plug on the engine oil gallery may not be correct to specification.This could lead over time to an oil leak which in rare cases could result in oil leaking on to the road.

Fix: The remedy consists of tightening the engine oil gallery sealing plug to the correct torque.

37 vehicles · built 30 Apr 2018 to 2 Jun 2018

An engine component may not be to specification which could result in loss of engine performance. This may lead to the engine stalling and potentially causing an engine failure. In very unlikely circumstances the vehicle speed may increase without warning but will stop on its own after a few seconds.

Fix: On affected vehicles carry out a functional diagnostic check of the engine. If necessary replace the engine.

198 vehicles · built 1 Oct 2017 to 30 Nov 2017

The positioning of the starter supply terminal may be incorrect. This may allow it to foul other components and cause a short circuit.

Fix: On affected vehicles check the positioning of the terminal and correct it if necessary.

12 vehicles · built 13 Jan 2016 to 30 Jun 2016

A possible nonconformity of an internal component of the starter motor relay could affect the control of the starter motor. This could adversely affect the starting operation and damage the starter motor due to overheating and in extreme cases there is a risk of fire.

Fix: On affected vehicles check and where necessary replace the starter motor relay.

3,607 vehicles · built 15 Jun 2016 to 11 Oct 2016

The tightening torque of one of the nuts of the connection between the brake servo unit and the brake pedal may be not correct to specification. This may allow air to enter the servo

Fix: Check servo security and where necessary replace the brake servo unit

2 vehicles · built 13 Apr 2016 to 29 Jun 2016

On the affected vehicles a possible non-conformity in the positioning of the fuel filler neck seal near the filler cap could cause a fuel leak when completely filling up the tank.

Fix: Checking and if necessary refit seal.

54 vehicles · built 2 Feb 2016 to 9 Jul 2016

The bolts retaining the front shock absorber could come loose. This may adversely affect the steering control of the vehicle.

Fix: On affected vehicles replace the front shock absorber retaining bolts.

1 vehicle