Lexmoto recalls

For affected machines when the front brake is applied whilst riding it is catching the brake pad securing pin. Examination has shown that an incorrect wheel spacer and incorrectly sized caliper holding bracket may have been fitted during manufacture.

Fix: Replacement of the front wheel spacer caliper bracket and brake pads.

192 vehicles · built 15 Jan 2025 to 26 Jun 2025

Incorrectly manufactured front wheel disc centre carriers may be subject to failure and may cause loss of control.

Fix: Do not ride the vehicle. Vehicles must be collected by a dealer and replacement front brake discs fitted.

35 vehicles · built 25 Jan 2022 to 1 Jun 2023

A bracket fitted under a previous recall has been discovered not to provide sufficient support to prevent shearing of the two securing bolts.

Fix: Install the stronger mounting bracket support plate and bolt kit.

516 vehicles · built 14 Feb 2017 to 15 Jan 2021

One of the locating bolts on the rear disc brake may not be sufficiently tight or include a locking compound.

Fix: Remove inspect clean and apply locking compound to all rear disc mounting bolts.

180 vehicles · built 10 Dec 2021 to 26 Aug 2022

The installed spacer on the rear wheel behind the rear wheel nut is the incorrect thickness this can cause the rear wheel nut to become loose and fall off.�

Fix: Replace the rear wheel spacer.

1,019 vehicles · built 1 Jun 2021 to 12 Jul 2022

The rear brake and exhaust bracket may�come into contact with�the road when the rear brake is applied if the securing bolts are to come loose.

Fix: To immediately stop riding and provide and fit a reinforced bracket with an extra securing point. Additionally provide a locking nut on the back of the securing bolt to help prevent the bolt coming loose.

698 vehicles · built 14 Feb 2017 to 15 Jan 2021

Possibility of a missing bush from the rear brake pedal pivot.

Fix: Inspect and fit a new bush if required and repair any consequential damage to associated components.

476 vehicles · built 13 Nov 2018 to 18 Aug 2020

Possible weak points in the frame that under certain conditions could fail.

Fix: Replace affected vehicles.

72 vehicles · built 13 Nov 2018 to 5 Jun 2019

The rear brake pads have exceeded the disc and once they have worn to a certain level then the rear brake may become inoperable. The front brake will still work as they are independent.

Fix: The dealers will be required to change the calliper mounting bracket and brake pads.

300 vehicles · built 4 Jul 2017 to 11 Jul 2017

The Combined Braking valve has a rubber washer fitted to a threaded fitment. The rubber washer isn�t suitable for the purpose and has shown signs of allowing hydraulic fluid to pass. If the seal was to completely fail it would result in a complete brake failure. The motorcycle would lose all braking ability which could result in a serious incident.

Fix: Recall the 225 machines that are likely to be affected and replace the front caliper two way valve brake hose and associated components.

225 vehicles · built 21 Jan 2017 to 25 May 2017

The Combined Braking valve has a rubber washer fitted to a threaded fitment. The rubber washer isn�t suitable for the purpose and has shown signs of allowing hydraulic fluid to pass. If the seal was to completely fail it would result in a complete brake failure. The motorcycle would lose all braking ability which could result in a serious incident.

Fix: Recall the 225 machines that are likely to be affected and replace the front caliper two way valve brake hose and associated components.

225 vehicles · built 21 Jan 2017 to 25 May 2017