Peugeot 307 recalls

In very rare circumstances the vacuum pump one way valve may not function correctly which could affect the level of braking assistance.

Fix: Recall the vehicles that are likely to be affected to replace the brake vacuum pump one way valve.

24,220 vehicles · built 15 Dec 2006 to 31 Mar 2009

It has been identified that the position of the exterior lighting control ring may not be detected by the lighting management system and the lights may switch off without warning.

Fix: Recalled vehicles will have the lighting management software updated.

2,903 vehicles · built 6 Jul 2007 to 7 Mar 2008

In rare cases the lighting management system may incorrectly detect the lighting switch ring position which may cause the lights to cut out.

Fix: Recall affected vehicles and download new version of vehicle exterior lighting software

48,938 vehicles · built 1 Oct 2006 to 27 Mar 2009

It has been identified that the main engine fuse box is not to the correct specification. This can result in operating faults or the failure of certain equipment.

Fix: Recalled vehicles will have the subject fuse box replaced.

7,360 vehicles · built 27 Feb 2008 to 9 Jun 2008

It has been identified that on the specified vehicles a fault may develop with the brake vacuum pump. This can result in hardening of the brake pedal with an attendant loss of braking efficiency.

Fix: Recalled vehicles will have the vacuum pump replaced.

19,867 vehicles · built 1 Jul 2005 to 31 Dec 2006

It has been identified that the operation of the ABS/ESP braking unit may be affected by the ingress of water.

Fix: Recall likely to be affected vehicles to reinforce the resistance of the ABS/ESP unit to water.

210,973 vehicles

The quality of the welding at the suspension mounting reinforcement plates may not be to specification.

Fix: Recall the vehicles that are likely to be affected and check the welding. Where necessary take corrective action to ensure that the reinforcement plate welding operation has been correctly completed.

221 vehicles

Due to a potential fault in the engine management system an internal engine fuel leak via the injectors may occur following switching off. This would result in the engine failing to restart due to excess fuel being present in the inlet manifold or cylinders.

Fix: To address the issue recalled vehicles will receive an engine management download.

4,338 vehicles

The incorrect fixing of the left hand curtain airbag can lead to incorrect deployment in the case of a left hand side impact or frontal impact with a high degree of angular bias to the left.

Fix: Recall the vehicles that are likely to be affected and re-fix the airbag correctly.

1 vehicle

It is necessary to check the fitting of the pedal box transfer bar levers on (RHD only). In rare cases where the return bar lever is faulty the braking efficiency could be affected.

Fix: Recalled vehicles will have the transfer bar checked and replaced if found to be faulty.

11,522 vehicles · built 5 Sep 2005 to 25 Oct 2005

It is necessary to check and reinforce the sealing of the electrical connections for the ABS system. As under certain conditions the repeated entry of salt water into this connection could cause short circuits which may lead to a fire within the engine compartment

Fix: Recalled vehicles will have numerous checks carried out and repairs completed dependent upon what is found.

151,100 vehicles

It is necessary to reinforce the sealing of electrical connections for the steering system electro pump assembly. As under certain conditions the repeated entry of salt water into this connection could cause short circuits which may lead to a fire within the engine compartment.

Fix: Recalled vehicles will have numerous checks carried out and repairs completed dependent upon what is found.

107,767 vehicles

There is a risk of a manufacturing non conformity on the fuel injection diesel return pipe. This may lead to the possibility of fuel seepage.

Fix: As a preventive measure likely to be affected vehicles will have the pipe replaced additionally the pipe will be fitted with protective sleeves.

2,573 vehicles

There is a risk that the lower swivel joint on the front suspension has not been sufficiently tightened.

Fix: Check the mounting and tightness of the joint if found out of specification replace the joint.

14,109 vehicles · built 15 Mar 2004 to 6 Jun 2004

The original engine software may cause erratic operation of the motorised throttle body. This could in rare extreme cases cause the throttle stop to break. This will cause the engine to revert to limp home mode which possible may cause a reduction in braking assistance.

Fix: Install updated software in the engine ECU.

8,599 vehicles

It is a possibility that vehicles may not be correctly fitted with a rear seat anchorage point strengthener. If the strengthener is not fitted the vehicle will not comply with the defined retention criteria in the case of an accident.

Fix: Recalled vehicles will be inspected for the presence of the seat anchorage strengthener. In cases where it is not in place the vehicle will be returned to specification.

150 vehicles · built 7 Jun 2003 to 19 Jun 2003

The possibility exists that the weld points on the chassis rear side members may not have been made correctly. With the result that in the case of an impact the vehicle would not comply with the energy absorption criteria.

Fix: Likely to be affected vehicles will be recalled for checking of the subject welds. If it is found that the welds are not to specification Product Service should be contacted.

303 vehicles · built 9 Feb 2004 to 12 Feb 2004

There is a possibility that the EGR support bracket may break and cause a short circuit which may stop the engine.

Fix: Recall affected vehicles and replace EGR bracket.

9,510 vehicles · built 28 Nov 2001 to 2 Oct 2003

Due to an incident during the vehicle manufacturing process there may be cuts in the side wall or tread of one or both of the tyres on the right hand side of the vehicle.

Fix: Examine the tyres fitted to the vehicle and replace any that are found to be cut.

554 vehicles · built 21 Aug 2003 to 21 Aug 2003

The automatic gearbox control wiring loom may become pinched. This may make it possible to start the engine whilst the car is in gear.

Fix: Check whether the wiring loom is being pinched. Repair and reposition the loom where found necessary.

102 vehicles · built 2 Aug 2002 to 9 Aug 2002

The front left hand anti-roll bar linkage may contact and chafe the brake pipe when turning the wheels to full left lock.

Fix: Inspect and where necessary reposition the left front brake pipe.

380 vehicles · built 2 May 2002 to 14 May 2002

It is possible that the brake fluid is not to the correct specification. this over a period of time could adversely affect the brake performance.

Fix: Replace the hydraulic fluid in the brake and clutch operating circuits.

91 vehicles · built 29 Aug 2002 to 30 Aug 2002

The front shock absorber lower yoke might not be to the correct specification. As a consequence the yoke may fracture and cause a deterioration in the vehicles road holding.

Fix: Recall affected vehicles and examine the front shock absorber lower support for cracks. Fit new shock absorbers where necessary.

647 vehicles

Key operation in the steering lock ignition switch may become stiff or could seize. An ignition switch seized in the start position could result in a starter motor burn out.

Fix: Replace the complete steering lock assembly.

28,876 vehicles