Peugeot Expert 4 recalls

Affected vehicles may have been equipped with rear brake discs out of specification. These brake discs have insufficient contact with the wheel hub resulting in abnormal stress concentration.

Fix: Check the rear brake discs and replace them and the brake pads if necessary.

7 vehicles · built 24 Jan 2024 to 24 Jan 2024

Vehicles may be affected by incorrect performance of the On-Board-Diagnostics related to Selective Catalytic Reduction system and/or Diesel Particle Filter. The Malfunction Indicator Light (MIL) may not illuminate in the event of a malfunction and therefore does not comply with emission regulations.

Fix: Update the Engine Control Unit software to ensure compliance to regulations.

vehicle count not given · built 2 Jun 2017 to 11 Oct 2021

On the affected vehicles equipped with a manual handbrake the efficiency of the handbrake and service brake may be compromised.�

Fix: Check the rear brake caliper references and replace as necessary.�

57 vehicles · built 20 Jan 2022 to 28 Jan 2022

Affected vehicles may have been equipped with headrests on the front modular seat which do not conform to the design specification.

Fix: Check the conformity of the front headrests (presence of the catch); in cases of non-conformity the front headrests will be replaced.

708 vehicles · built 16 Nov 2021 to 16 Dec 2021

The rear window electrical harness could become displaced from its original position and present a potential thermal issue.

Fix: Check the routing of harness and replace the electrical harness if necessary. Add a fastening clip to ensure that the electrical harness will be maintained in its normal position.

51 vehicles · built 16 Nov 2015 to 13 Oct 2016

The rear spring centraliser might be welded incorrectly.

Fix: Add 3 weld spots to the rear spring centralisers

2 vehicles · built 15 Apr 2021 to 29 Apr 2021

A single wheel bolt on both right-hand wheels may not be tightened to the correct tightening torque.

Fix: Check and if necessary replace wheel bolts and any other associated parts if consequential damage has occurred.

4 vehicles · built 24 Sep 2020 to 11 Nov 2020

A single wheel bolt on both left-hand wheels may not be tightened to the correct tightening torque.

Fix: Check and if necessary replace wheel bolts and any other associated parts if consequential damage has occurred.

11 vehicles · built 24 Sep 2020 to 11 Nov 2020

A rear seat longitudinal adjustment lever may not lock properly.

Fix: Check affected seat frames and replacing them if necessary.

11 vehicles · built 19 Nov 2019 to 27 Feb 2020

There is a risk of inadvertent release to the front outer passenger seat belt.

Fix: Modifying the central seat buckle with foam and heat-shrinkable protective tubing

16,828 vehicles · built 16 Apr 2015 to 23 Apr 2019

Possible slackening of the front wishbone ball joint.

Fix: Increasing the tightening torque of the ball joint and adding thread lock if the ball joint threads are found to be rusty or loose the ball joint will be replaced

• EXPERT 4: 10,936 vehicles · built 27 Aug 2015 to 23 Nov 2018
• EXPERT 4: 10,936 vehicles · built 16 Apr 2015 to 23 Apr 2019

Excessive loading of the front suspension could result in the loosening of the front wishbone lower ball joints.

Fix: Increasing the tightening torque of the ball joint and adding thread lock to the ball joint threads if the ball joint threads are found to be rusty the ball joint will be replaced.

2,942 vehicles · built 1 Jan 2015 to 30 Nov 2018

The fixing bolt of the front Suspension wishbone may not be correct to specification.

Fix: Replace the fixing bolts and nuts of the front suspension wishbones.

21 vehicles · built 1 Jul 2016 to 11 Sep 2018

The rear suspension wishbone mountings bolts may not be correct to specification.

Fix: Replacement of the rear suspension wishbone bolts.

326 vehicles · built 5 Oct 2016 to 18 Oct 2018

The air conditioning compressor pulley could break and damage other components.

Fix: Replace the air conditioning compressor pulley and if necessary the protective cover.

2,643 vehicles

The steering rack assembly may not be correct to specification.

Fix: Replace the steering rack assembly and the fixings.

14 vehicles · built 4 Oct 2016 to 8 Oct 2018

The tow ball bracket could not withstand mechanical constraints when subjected to the highest stress levels which can occur during the vehicle's lifetime.

Fix: The manufacturer�s remedy involves the replacement of the tow ball support bracket with a redesigned version.

96 vehicles · built 13 Nov 2015 to 5 Oct 2017

The cooling system strategy and the maximum temperature alert could cause the engine to overheat this may cause an oil leak from the sump drain cap. Due to the incorrect operation of the warning system there is no driver alert.

Fix: The remedy involves downloading new engine management software.

841 vehicles · built 10 Mar 2016 to 24 Feb 2018

On the affected vehicles the tightening of a sealing plug on the engine oil gallery may not be correct to specification.This could lead over time to an oil leak which in rare cases could result in oil leaking on to the road.

Fix: The remedy consists of tightening the engine oil gallery sealing plug to the correct torque

47 vehicles · built 30 Apr 2018 to 1 Jun 2018

An engine component may not be to specification which could result in loss of engine performance. This may lead to the engine stalling and potentially causing an engine failure. In very unlikely circumstances the vehicle speed may increase without warning but will stop on its own after a few seconds.

Fix: On affected vehicles carry out a functional diagnostic check of the engine. If necessary replace the engine.

314 vehicles · built 1 Oct 2017 to 30 Nov 2017

The positioning of the starter supply terminal may be incorrect. This may allow it to foul other components and cause a short circuit.

Fix: On affected vehicles check the positioning of the terminal and correct it if necessary.

16 vehicles · built 15 Dec 2015 to 30 Jun 2016

Possible non-compliance of an internal component of the starter control relay could cause damage by overheating. This could cause unintended operation of the starter motor and in extreme instances; there is a risk of fire.

Fix: On affected vehicles check and if necessary replace the relay

84 vehicles · built 25 Jun 2016 to 10 Sep 2016

The tightness of one of the air conditioning compressor support mountings may not be correct to specification. This will result in an abnormal noise and possibility of the compressor becoming insecure

Fix: On affected vehicles check the tightness of the support; where necessary the support will be replaced.

1,326 vehicles · built 1 Jan 2016 to 6 Mar 2017

A possible nonconformity of an internal component of the starter motor relay could affect the control of the starter motor. This could adversely affect the starting operation and damage the starter motor due to overheating and in extreme cases there is a risk of fire.

Fix: On affected vehicles check and where necessary replace the starter motor relay.

6,768 vehicles · built 15 May 2016 to 12 Oct 2016

A component in the gearbox actuator may not be to the correct specification which may affect gear selection.

Fix: On affected vehicles replace the gearbox actuator

13 vehicles · built 13 May 2016 to 25 Aug 2016

It has been identified that the wheel bolts may not have been tightened to the correct specification. The driver may experience a vibration through the steering wheel. However it not rectified there is a risk that the wheels may become damaged over time or the wheel could in extreme cases could detach from the vehicle whilst driving. This could cause loss of control of the vehicle.

Fix: Recall all affected vehicles to check the tightness of the road wheel bolts and rectify as necessary. In certain cases the replacement of the bolt(s) and wheel(s) may be necessary.

42 vehicles · built 17 Feb 2016 to 29 Sep 2016

It has been identified that the fuel filler neck assembly may not have been correctly installed at production. This can therefore result in a fuel leak from around the fuel filler area if the fuel tank is filled to maxumum or can fuel leak if the vehicle rolls over..

Fix: Recall all affected vehicles to check fuel filler neck and rework/rectify if required.

58 vehicles · built 1 Feb 2016 to 9 Jul 2016