Toyota Corolla recalls

For certain vehicles equipped with the combination meter system (where various information is displayed) that due to an improper programming of the combination meter unnecessarily repetitive data is written to a memory device. This may cause the memory device to deteriorate and the monitor to not display during the meter at start up and remain in this state permanently.

Fix: Reprogram or replace the combination meter.

30,141 vehicles · built 19 Aug 2022 to 6 May 2025

For certain vehicles that were affected by a previous campaign announced in October 2023 for high-pressure fuel pump a further check is required to confirm if the correct pump is fitted.

Fix: A check of the high-pressure fuel pump and replace if necessary.

180 vehicles · built 1 Dec 2018 to 30 Nov 2022

For certain vehicles there is an issue involving the skid control software of the skid control Electronic Control Unit (ECU) where a hard brake pedal feel cannot be ruled out.

Fix: The remedy for the concern will be to reprogram the Brake Actuator (Skid control ECU)

31,809 vehicles · built 16 Jan 2023 to 5 Nov 2024

Affected vehicles are fitted with a high-pressure fuel pump which over time could develop a crack which could lead to a fuel leak and a risk of a vehicle fire.�

Fix: Check and replace high pressure fuel pump if necessary.�

5,440 vehicles · built 18 Jun 2018 to 10 Nov 2022

On affected vehicles there is a possibility that the DCM may not complete the shutdown process within a specific period of time when the ignition is turned off causing the DCM to not restart at the next ignition cycle and making the e-Call function unavailable. As a result the vehicles do not comply with relevant regulations.

Fix: The software of the DCM (Data Communication Module) will be updated via an Over the Air (OTA) wireless update.

27,327 vehicles · built 14 Dec 2020 to 4 Aug 2023

The emergency calling system (eCall) may not function when required.

Fix: Inspect the emergency calling system and update DCM software. If the DCM is found to be damaged replace it with updated software.

• COROLLA: 26,575 vehicles · built 5 Oct 2020 to 19 Feb 2021
• COROLLA: 26,575 vehicles · built 4 Nov 2020 to 23 Feb 2021

The inside of the high-pressure fuel pump may be worn or damaged over time during operation.

Fix: Inspect* and if necessary replace the high-pressure fuel pump. (*Based on engine variant and/or pump manufacturer/pump serial number.)

5,440 vehicles · built 18 Jun 2018 to 10 Oct 2019

A possibility that the Exhaust Gas Recirculation (EGR) cooler could develop an internal coolant leak

Fix: Replace the EGR cooler in all involved vehicles and if necessary replace the inlet manifold.

24,241 vehicles · built 2 Mar 2015 to 9 Nov 2017

A possibility that a bolt of the brake pedal bracket may not have been torqued correctly.

Fix: Tighten the bolt of the brake pedal bracket to the appropriate torque.

9,751 vehicles · built 15 Jun 2019 to 20 May 2020

The panoramic roof deflector may not be secured correctly.

Fix: Inspect and repair the panoramic roof deflector as necessary.

19 vehicles · built 24 Jan 2019 to 15 Feb 2019

There is a possibility that the emergency calling system has not been activated.

Fix: Inspect and activate the emergency call system if necessary.

3,484 vehicles · built 31 Oct 2018 to 6 Apr 2019

Possible fuel leak from fuel tank.

Fix: Replace the fuel tank emission control Canister.

85,909 vehicles · built 30 Aug 2007 to 11 May 2010

Possible inadvertent air bag deployment.

Fix: Replace the airbag sensor assembly.

131,435 vehicles · built 9 Jul 2002 to 11 Jun 2004

Passenger air bag may cause injury if activated.

Fix: Replace affected air bag assembly.

99,588 vehicles · built 29 Aug 2000 to 1 Feb 2007

Affected vehicles received a recall remedy in which the replacement inflator may have been installed in an incorrect orientation.This may prevent the front passenger air bag from inflating as intended during deployment as designed.

Fix: Affected vehicles will have the inflator checked and corrected if it is necessary.

12,182 vehicles · built 12 Dec 2010 to 4 Oct 2016

It has been identified that vehicles equipped with a single stage inflator driver�s front air bag then there is a possibility that the density of the propellant in the inflator could be reduced over time from the effects of high temperature cycling and moisture within the propellant and its sealed container. This may cause the propellant to degrade which if this occurs then the inflator could rupture in the event of the deployment of the driver�s front air bag.

Fix: Recall all affected vehicle to replace the driver's front air bag.

• COROLLA: 56,143 vehicles · built 6 Jan 2003 to 26 Mar 2004
• COROLLA: 56,143 vehicles · built 7 Oct 2002 to 11 Jun 2004
• COROLLA: 56,143 vehicles · built 30 Jul 2004 to 18 Sep 2004
• COROLLA: 56,143 vehicles · built 2 Nov 2001 to 10 May 2004

It has been identified that in the subject vehicles there is a possibility the container of the inflator of the driver�s side may rupture. Toyota has not been able to establish the cause of the failure and is conducting a safety recall to recover the relevant parts to enable them to investigate the cause of the failure.

Fix: Recall the affected vehicles to replace the driver's side airbag inflator.

1,248 vehicles · built 13 Sep 2002 to 17 Jan 2003

Affected vehicles are equipped with a driver�s side Power Window Master Switch (PWMS) containing sliding electrical contact modules. These modules may not have been incorrectly coated during the manufacturing process. This may cause a short circuit which could cause the switch to overheat and melt

Fix: Inspect switch and apply coating. If switch indicates signs of malfunction it should be replaced.

123,306 vehicles · built 13 Jun 2005 to 31 Dec 2010

The subject vehicles are equipped with front passenger airbag inflators which could have been assembled with improperly manufactured propellant wafers. Improperly manufactured propellant wafers could cause the inflator to rupture and the front passenger airbag to deploy abnormally in a crash. This could result in increased risk of injury to the occupant and the possibility of a fire.

Fix: Recall the vehicles that are likely to be affected to replace the airbag.

• COROLLA: 542,751 vehicles · built 1 Feb 2001 to 30 Mar 2007
• COROLLA: 542,751 vehicles · built 25 Oct 2006 to 24 Nov 2008
• COROLLA: 542,751 vehicles · built 10 May 2004 to 5 Jun 2007
• COROLLA: 542,751 vehicles · built 1 Feb 2007 to 30 Mar 2007

Oil may accumulate in the turbo charger and in certain circumstances flow into the combustion chamber. This may cause engine damage. In extreme cases oil can be ejected from the engine and if it comes in contact with an ignition source may result in a fire.

Fix: Depending vehicle diagnosis modify intercooler layout to improve air flow; upgrade ECU software; upgrade turbo charger and/or vacuum pump

7,884 vehicles · built 17 Nov 2008 to 19 Nov 2014

The subject vehicles are equipped with front passenger airbag inflators which could have been assembled with improperly manufactured propellant wafers. Improperly manufactured propellant wafers could cause the inflator to rupture and the front passenger airbag to deploy abnormally in a crash. This could result in increased risk of injury to the occupant and the possibility of a fire.

Fix: Recall the vehicles that are likely to be affected to replace the airbag.

85,405 vehicles · built 8 Jan 2001 to 15 Nov 2003

It is possible that the splines of the extension shaft on vehicles equipped with Electric Motor assisted Power Steering (EMPS) may not have received the correct hardness treatment. This can cause the spline to distort and wear and eventually result in loss of steering.

Fix: Recall affected vehicles check and if necessary replace the shaft.

• COROLLA: 61,910 vehicles · built 6 Jul 2001 to 31 Mar 2004
• COROLLA: 61,910 vehicles · built 21 Aug 2002 to 14 Oct 2008

It is possible that the connections at the intermediate shaft and sliding yoke of the steering column may become loose and if the symptoms are ignored steering control can be lost.

Fix: Recall the vehicles that are likely to be affected and replace the steering intermediate shaft. In addition inspect the sliding yoke and intermediate shaft extension and replace if necessary. This recall is staggered starting with Prius and Corrolla. Avensis customer letters will be sent out over the next three months

• COROLLA: 39,372 vehicles · built 1 Oct 2001 to 1 Jun 2002
• COROLLA: 39,372 vehicles · built 1 Oct 2001 to 30 Jun 2002

Due to an improper washing process of a metal part within the brake master cylinder there is a possibility that the groove for installing the rubber seal ring which is located at the end of the master cylinder may be corroded. In this condition brake fluid may leak from the seal or a small amount of air may enter the master cylinder which could lead to an increase in vehicle stopping distance.

Fix: Vehicles that are likely to be affected will be checked and a quality assured part fitted if necessary.

6,936 vehicles · built 1 Sep 1999 to 1 Sep 2000

The front passenger airbag inflator module check valve pin is missing in the affected vehicle. In the event of airbag activation the partition which separates the inflator and the bag may not be properly broken resulting in insufficient pressure to properly deploy the airbag. This could result in injury to the front seat passenger in the event of a frontal impact.

Fix: Replace the inflator module.

1 vehicle · built 25 Oct 2000 to 25 Oct 2000

Transmission output shaft critical dimension may be shorter than the specification. In the worst case this could result in two gears being selected at the same time and cause the gearbox to lock up.

Fix: Check transmission serial number and replace any gearbox found to be within the affected range.

50 vehicles · built 3 Aug 2002 to 9 Oct 2002

Certain brake master cylinder reservoir cap air vents are blocked. If the vehicle is driven in this condition for long term a vacuum is created in the reservoir tank as brake pads wear. There is a possibility that this vacuum may cause the brake pedal stroke to increase.

Fix: Recall affected vehicles and replace reservoir cap if faulty.

4,025 vehicles · built 5 Mar 2002 to 30 May 2002

It is possible for the bolts to be loose that join the rear brake and hub assembly to the rear axle carrier due to insufficient tightening. 1 or more of the 4 bolts could come loose causing an abnormal noise from the rear wheel axle area. In the event that all 4 bolts loosen completely separation of the rear brake and hub assembly from the rear axle carrier may occur which in the worst case could lead to a loss of vehicle control.

Fix: Recall affected vehicles and check the rear brake and hub securing bolts for correct tightness.

6,617 vehicles · built 22 Nov 2001 to 4 Apr 2002