Iveco Eurotech recalls

There is a possibility that contaminated air maybe drawn into the engine air intake system (eg Cigarette ends)

Fix: Recall affected vehicles and fit a protective grille over the air intake pipe

1,747 vehicles · built 22 Apr 1998 to 3 Jul 2003

It is possible that the cab top and side spoiler brackets may not be securely bonded (glued) to the cab structure.

Fix: Check the glued mountings on the top and side spoiler with a spring balance to 40-50 kg. If the bond fails reglue the brackets as per the manufacturer's instructions.

3 vehicles

Front brake hoses may have been incorrectly fitted. This could result in an air leak when the footbrake is applied.

Fix: Check brake hose connections for tightness and leaks. Rectify where necessary.

8 vehicles

An incorrect length steering column shaft may have been fitted during manufacture.

Fix: Check the length of the column shaft and replace where necessary.

8 vehicles

There is the possibility of an air loss from the footbrake system due to corrosion in the pressure regulator APU valve (air dryer with four circuit safety valve].

Fix: To prevent corrosion in the pressure regulator APU a new rubber diaphragm will be fitted.

1,872 vehicles · built 17 Apr 1998 to 27 Jun 2002

The rear brake caliper retaining bolts may have been under torqued.

Fix: Recall affected vehicles and check the tightness of the relevant bolts. Renew any bolts found to be under torqued.

33 vehicles · built 1 Jan 2000 to 31 May 2000

There is a possibility that a braking imbalance may occur due to the fitment of an incorrect sized brake cylinder.

Fix: Recall affected vehicles to check and replace if required a brake cylinder.

144 vehicles · built 1 Jan 1999 to 31 Dec 2000

The drivers cab tilt cylinder support bracket may fail resulting in the cab collapsing when tilted.

Fix: Recall affected vehicles and replace the support bracket with a modified type.

21 vehicles · built 1 Jan 1998 to 31 Dec 2000

Operation of automatic engine brake switch may cause the rear wheels to lock on unladen vehicles not fitted with ABS.

Fix: Recall potentially affected vehicles and remove the automatic engine braking control switch.

6 vehicles · built 1 Dec 1998 to 30 Jun 1999

Some models fitted with pneumatic suspension are equipped with rotatable connectors on the rear axle brake hose connections. These connectors may leak with an adverse effect on braking performance.

Fix: Recall the affected vehicles for inspection of the connector type fitted and where necessary revise to non-rotatable connectors

1,370 vehicles · built 1 Jan 1995 to 31 Jan 1996

A steel ball used to seal an aperture in the parking brake control valve may become displaced and could result in inadvertent application of the parking brake.

Fix: The affected vehicles are being recalled to be inspected for the make of parking brake valve fitted. A securing clamp will be fitted to all the affected units to prevent displacement of the ball.

4,332 vehicles

It has been decided to reinforce the steering linkage reversing levers to enhance long term durability.

Fix: Recall the affected vehicles and replace the original steering levers with reinforced examples.

304 vehicles · built 1 Jan 1993 to 31 Mar 1994

The service brake foot control valve may be defective. This could result in the loss of both braking circuits.

Fix: Recall the defective vehicles to check the subject valve. Defective valves will be replaced with a new unit.

44 vehicles

Possible leakage of fuel on the low pressure side of the system.

Fix: Recall the affected vehicles examine and rectify any sources of fuel leakage and modify two connections within the system by the fitment of revised connectors.

817 vehicles · built 1 Nov 1992 to 31 Oct 1993