Peugeot 107 recalls

On the affected vehicles the bonding of the rear door window glass to the hinge assemblies may not conform to specification.

Fix: Check and if necessary replace the rear window or re- bond the rear window glass hinges.

70,171 vehicles · built 1 Feb 2005 to 21 Nov 2013

The front shock absorber rod may have an internal fault which could cause it to brake. This could have an adverse affect on the front suspension and the driver's ability to control the vehicle.

Fix: On affected vehicles replace both front shock absorbers.

1,544 vehicles · built 20 Sep 2013 to 12 Nov 2013

On subject vehicles a weld on the rear cross member might be non-compliant and eventually cause the weld between the cross member and the vehicle body to break. This may lead to a partial detachment of the axle and cause the driver to lose control.

Fix: Contact keepers using DVLA and manufacturer's records.Check the compliance of the weld on the O/S/R and if necessary replace the cross member.

453 vehicles · built 25 Jul 2013 to 31 Jul 2013

It is possible that the con-rod bearing shells will not conform to manufacturer specification. This could lead to premature deterioration of the shells and in time cause the engine to fail.

Fix: To replace the con-rod bearing shells

1,851 vehicles

The left hand side front chassis may have a nonconformity which may lead to a risk of poor securing of the suspension arm.

Fix: Recall the vehicles that are likely to be affected to replace the left hand side front chassis member.

3 vehicles · built 15 Feb 2011 to 15 Feb 2011

It has been identified that within the mechanism of the accelerator pedal there is a friction lever which interacts with a sliding surface. Over time and under certain conditionsthe contact surfaces may generated excessive friction and latterly the movement of the accelerator pedal. This over time and under certain conditions will result in the accelerator pedal becoming intermittently more difficult to push; or slower to return. In rare instances the accelerator pedal can remain in the partially depressed position.

Fix: Recalled vehicles will have a reinforcing plate fitted within the accelerator pedal mechanism which will ensure continued correct functionality.

6,380 vehicles

A possible substandard tapping of one or more of the wheel stud holes may result in a reduction of the wheel stud to hub torque setting.

Fix: Recall affected vehicles and replace hubs.

110 vehicles · built 19 May 2009 to 26 May 2009