Peugeot 206 recalls

It is possible that the con-rod bearing shells will not conform to manufacturer specification. This could lead to premature deterioration of the shells and in time cause the engine to fail.

Fix: To replace the con-rod bearing shells

1,851 vehicles · built 20 May 2010 to 8 Jul 2010

It has been identified that on subject vehicles a fuel pipe may not be correctly sealed. Should this be the case seepage of fuel may occur.

Fix: Recalled vehicles will have the subject fuel pipe checked and replaced as necessary.

61 vehicles · built 3 Jul 2008 to 16 Jul 2008

It has been identified that on subject vehicles the windscreen wiper mechanism has not been manufactured to specification. As a result in time the windscreen wipers could fail.

Fix: Recalled vehicles will have the windscreen wiper mechanism replaced.

17,551 vehicles · built 1 Dec 2005 to 31 May 2006

It has been identified on a small number of vehicles that the spacer for the front right-hand seat belt fixing bolt may have been incorrectly fitted. It is therefore possible that in time this could result in the fixing for the assembly becoming insecure.

Fix: Recalled vehicles will have the fitting of the spacer checked for compliance with the specification. If found to be necessary the trim will be repositioned and the assembly re-tightened to the correct torque.

4 vehicles

There is a risk of a manufacturing non conformity on the fuel injection diesel return pipe. This may lead to the possibility of fuel seepage.

Fix: As a preventive measure likely to be affected vehicles will have the pipe replaced additionally the pipe will be fitted with protective sleeves.

2,573 vehicles

The possibility exists that the starter motor wiring loom has been positioned incorrectly. In consequence there is a risk that this could cause a short circuit.

Fix: Recall likely to be affected vehicles and correctly fit the wiring loom.

1,128 vehicles · built 1 Jun 2004 to 13 Jul 2004

The software may cause erratic operation of the motorized throttle which may result in breakage of the throttle stop. This can result in the engine reverting to limp home mode with a possible reduction in braking assistance.

Fix: Subject vehicles will be recalled and the condition eradicated by carrying out an ECU download.

2,735 vehicles

The spoiler mounting on the rear tailgate may in certain cases have some weak points and cause some noise.This may even lead to the loss of the spoiler

Fix: Recall affected vehicles and replace the 4 spoiler fixing bolts and fit two safety straps

5,388 vehicles · built 28 Nov 2001 to 2 Oct 2003

It is necessary to exchange the two clevis pins on the brake pedal system to avoid any loss of braking. Peugeot have experienced a limited number of incidents where one of the pins has not been locked properly during fitting.

Fix: Recall the potentially affected vehicles and replace the two clevis pins on the brake pedal system.

284,339 vehicles · built 1 Sep 1998 to 28 Feb 2002

There is a possibility that the steering column cowling may move out of alignment causing the ignition switch to foul on the steering cowling and possibly stick in the start position.

Fix: Recall affected vehicles and check and where necessary replace the steering column clamp. The cowling unit is replaced on all vehicles recalled.

12,747 vehicles

There is a risk that the lower attachment on the front and rear left hand seat belts could be loose.

Fix: Recall the affected vehicles to check and if necessary tighten the seat belt fixings.

23 vehicles

Incorrect specification passenger airbag internal module.

Fix: Recall affected vehicles replace airbag.

86 vehicles

There is a possibility that the front stub axle lower ball joint fixing may have been incorrectly machined which may result in separation of the stub axle from the ball joint/lower suspension arm.

Fix: Recall affected vehicles to check and if required replace the left and right stub axles which will be carried out free of charge.

384 vehicles

Possibility of unintentional deployment of either side air bags

Fix: Recall affected vehicles and replace both side air bag control units.

1,416 vehicles

There is a possibility that fuel may seep from fuel filter housing due to external corrosion. A fire risk may exist.

Fix: Recall affected vehicles and replace aluminium fuel filter with a plastic fuel filter.

49,235 vehicles · built 1 Sep 1998 to 22 Sep 1999