Peugeot 607 recalls

In very rare circumstances the vacuum pump one way valve may not function correctly which could affect the level of braking assistance.

Fix: Recall the vehicles that are likely to be affected to replace the brake vacuum pump one way valve.

24,220 vehicles · built 15 Dec 2006 to 31 Mar 2009

Residual low pressure persists in the power braking vacuum circuit which may result in the loss of power assistance when braking

Fix: Recall affected vehicles to fit a calibrated air vent in the vacuum circuit.

1,186 vehicles · built 1 Mar 2004 to 31 May 2007

It has been identified that a slight amount of play in the diesel fuel return pipe mountings on certain vehicles may over time lead to abrasion and wear of the pipe.

Fix: Recalled vehicles will have the subject clips checked and the pipe secured.

2,323 vehicles

It has been identified that on the specified vehicles a fault may develop with the brake vacuum pump. This can result in hardening of the brake pedal with an attendant loss of braking efficiency.

Fix: Recalled vehicles will have the vacuum pump replaced.

19,867 vehicles · built 1 Jul 2005 to 31 Dec 2006

It is possible that the engine may stall when lifting your foot off of the accelerator immediately after high speed usage of the vehicle.

Fix: Recall the vehicles that are likely to be affected to download a new piece of software to the engine ECU.

635 vehicles

Due to a potential fault in the engine management system an internal engine fuel leak via the injectors may occur following switching off. This would result in the engine failing to restart due to excess fuel being present in the inlet manifold or cylinders.

Fix: To address the issue recalled vehicles will receive an engine management download.

4,338 vehicles

Incorrect manufacture of the rear bench seat bolsters could in the case of an impact hinder the deployment of the rear lateral airbags.

Fix: Recall the vehicles that are likely to be affected and fit modified seat bolsters.

20 vehicles · built 31 Aug 2004 to 30 Sep 2004

It is necessary to protect the battery supply circuit to prevent any possible risk of an electrical short circuit

Fix: Fit a replacement battery negative cable fitted with a maxi fuse also fit protective felt to the aluminium section of the air conditioning pipes to insulate them from the battery positive cable.

3,696 vehicles

Possible non-conformity of the rear suspension triangles could in rare cases of stress lead to their deformation.

Fix: Fit new right and left side lower suspension triangles.

594 vehicles

The front right hand lower suspension arm may not be to specification. As a consequence it may deform under certain impact loads.

Fix: Check the identification markings on the suspension arm and replace where necessary.

79 vehicles