Peugeot Bipper recalls

Over time partial wear of the gearbox control harnesses may occur due to contact with surrounding components. Gear selection may be affected as a result of electrical faults in some rare cases including the lighting of the warning lamp on the instrument panel and the driveability of the vehicle may be compromised.

Fix: Recall the vehicles that are likely to be affected to check the condition of the gearbox control harness and where necessary fit additional protection.

428 vehicles · built 24 Apr 2008 to 18 Aug 2010

One of the vacuum hose unions in the braking system may not be to specification. This could cause a reduction in braking assistance.

Fix: Check and if necessary replace the hose.

78 vehicles · built 25 Jun 2012 to 1 Aug 2012

It is possible that the con-rod bearing shells will not conform to manufacturer specification. This could lead to premature deterioration of the shells and in time cause the engine to fail.

Fix: To replace the con-rod bearing shells

1,851 vehicles · built 20 May 2010 to 8 Jul 2010

Over a period of time a small crack can appear on the rear axle cross member particularly under conditions of repeated maximum suspension travel. The small crack could increase in size and eventually lead to the rear wheel rubbing on the wheel arch.

Fix: Replace the rear axle cross member and suspension bump stops.

6,192 vehicles · built 5 Mar 2009 to 28 Sep 2010

There may be a fault in the machining of the crankshaft that could lead to a lubrication problem which overtime could lead to the engine seizing.

Fix: The recalled vehicles will have the engine replaced.

132 vehicles · built 5 May 2010 to 18 May 2010