Peugeot Boxer III recalls

Vehicles may be affected by incorrect performance of the On-Board-Diagnostics related to Selective Catalytic Reduction system and/or Diesel Particle Filter. The Malfunction Indicator Light (MIL) may not illuminate in the event of a malfunction and therefore does not comply with emission regulations.

Fix: Update the Engine Control Unit software to ensure compliance to regulations.

16,718 vehicles · built 14 Mar 2018 to 9 Apr 2024

On affected vehicles the hydraulic power steering hose is not according to specification which could lead to deterioration in power steering assistance or sudden loss of steering assistance.

Fix: Check and replace power steering hose if necessary.

3,122 vehicles · built 20 Mar 2023 to 1 Sep 2023

The chrono tachograph fitted was not to the correct specification and does not meet Regulatory Requirements.

Fix: Replace the chrono tachograph manual transmission electrical harness & windshield.

41 vehicles · built 2 Jan 2019 to 13 Jul 2020

The brake pipe fixings may not conform to specification

Fix: Checking and repairing these fixings and replacing any damaged pipes as necessary.

41,911 vehicles · built 5 Jul 2016 to 17 Jun 2019

The electrical switch of the steering lock may not conform to specification. This could cause the intermittent unwanted switching off of information displays on the instrument panel.

Fix: Recall the vehicles that are likely to be affected and replace the ignition switch.

8,915 vehicles · built 30 Sep 2014 to 16 Jun 2015

An internal component of the injector may not be to specification which could reduce the fuel pressure in the injection system. The concern can prevent the engine starting and/or cause the engine to stall.

Fix: Recall the vehicles that are likely to be affected and check the identification number of the engine injectors. Where necessary replace the injectors.

1,475 vehicles · built 5 Sep 2014 to 12 Dec 2014

On the affected vehicles the fixing of the handbrake cable support stop may not be to specification which could cause long term loss of handbrake efficiency.

Fix: The strengthening of the fixing of the handbrake cable support stop on the chassis. This operation will avoid any long term loss of handbrake efficiency.

1 vehicle · built 31 May 2012 to 31 May 2012

It has been identified that; with the engine switched off the side indicator repeaters do not operate when the parking lights are on.

Fix: Recalled vehicles will have the relevant operating software upgraded.

24 vehicles

It has been identified that a problem may arise with the steering mechanism which can result in hardness whilst manoeuvring.

Fix: Recalled vehicles will have the steering mechanism checked and lubricated. The mechanism will be replaced if found to be damaged. At the same time certain vehicles will have key components reinforced against the ingress of water. Thus preventing operating faults in the long term.

3,594 vehicles

Some vehicles may have been fitted incorrect specification flexible brake hoses which if not checked and replaced could lead to a brake failure.

Fix: Recall all affected vehicles for inspection of the flexible brake hoses and replacement if found to be out of specification.

382 vehicles

It has been identified that the welding operation on the sleeve end panel of the handbrake system may not have been correctly carried out. This could result in greatly reduced handbrake efficiency.

Fix: Recalled vehicles will have the subject assembly strengthened.

15 vehicles