Toyota Landcruiser recalls

For certain vehicles equipped with a Parking Assist ECU a component of the Panoramic View Monitor (PVM) system that displays the rear view image the software may cause the rear view image to freeze or not display

Fix: Reprogram the parking assist ECU.

808 vehicles · built 2 Feb 2024 to 1 Sep 2025

The urea water injector mounting flange on the exhaust front pipe may fail and allow the urea water injector to separate from the front pipe. This situation could result in noncompliance with requirements prescribed in applicable safety or emission regulations in the involved countries.

Fix: Recall the vehicles that are likely to be affected and replace front exhaust pipe.

589 vehicles · built 8 Jun 2015 to 26 Jan 2016

If the vehicle is subject to unusually severe impacts to the front wheel it is possible that the fixing component on the steering shaft can become disengaged. If this occurs and the steering is repeatedly placed on full lock it is possible that over time the steering shaft could become disconnected so resulting in loss of directional control.

Fix: Recall affected vehicles to check shaft and relace fixing component with a new design. If the shaft is found to be damaged this will be relaced also.

353 vehicles · built 31 Jul 2002 to 26 Sep 2006

Due to insufficient strength of the rear axle drive shaft flange a fracture might develop under certain driving conditions. In the worst case the flange may become detached causing the vehicle to become immobilised.

Fix: Recalled vehicles will have the right and left hand rear axle drive shafts replaced.

7,606 vehicles · built 17 Apr 1996 to 6 Jan 1999

Due to a manufacturing issue with the fron t suspension lower ball joints there is a possibility that the surgace of the ball joints may have been scrateched. If the vehicle is operated gor an extended period of time in this condition the ball joints may experience excessive wear and looseness causing noise and vibration in the front suspension. In extreme cases the lower ball joints may separate from the knuckle causing a loss of vehicle steering control.

Fix: Recall the vehicles that are likely to be affected and replace the lower suspension control arm ball joints.

2,218 vehicles · built 22 May 2001 to 21 Dec 2001

The front seat belt installation may be loose at its uppermost position on the B post due to incorrect reinstallation following conversion to a commercial vehicle.

Fix: Examine the front seat belt installation and correct and make secure where found necessary.

437 vehicles · built 1 Aug 1996 to 31 Aug 2002

The fuel injection system pulsation damper may have been damaged during manufacture. As a consequence it may leak and cause a fire hazard in the presence of a heat or ignition source.

Fix: Fit a modified pulsation damper.

131 vehicles · built 29 Mar 2002 to 22 Mar 2003

The rotor blades in the brake vacuum pump may have a rough surface and be subject to wear. In the worst case the blades may break causing loss of brake vacuum assistance and resulting in increased stopping distances.

Fix: The affected vehicles are being recalled to Toyota Dealers for replacement of the vacuum pump blades and rotor.

3,349 vehicles · built 1 Dec 1989 to 30 Jun 1994